Home > NSF250R > NSF250R Engine >

Hot Rod top-end Kit for NSF250R
Hot Rod top-end Kit for NSF250R
 
Alternative Views:
: $2,521.49


Product Code: HRK-NSF
Qty:

Description
 
Hot Rod top-end kit for all NSF250
Kit comes compete with all parts needed for the top-end rebuild and upgraded with 'Hot Rod' parts.

Parts will be shipped directly to G-Force Performance. Send your engine (or entire bike) to them, and they will install the kit, flow your stock head, degree the cams, etc. (service fees from G-Force will apply)

The kit has been dyno tested and produced an additional 18-22% HP over stock engine with only an aftermarket exhaust. Will work great with stock exhaust too. Obviously, every engine is different, but you will feel a significant improvement in power, top speed, and throttle response from this kit and G-Force Performance installation and setup. The stock HRC parts needed for this same rebuild is $1673. Additionally, they recondition the cylinder head so you don't need to replace it per HRC spec, saving another $664. So, for less than $300 over stock parts prices, you get a big power boost!

Kit includes the following parts:
Custom high compression piston
Custom Titanium valves
Custom Camshaft
HRC piston rings, circlips, pin
HRC head, base, spacer, and exhaust gaskets
HRC valve springs, seals, retainer, cotter clips
NGK Spark plug
New oil filter

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

NSF250R > NSF250R Engine


YAMAHA - clip - SOLD OUT $13.45
YAMAHA - protector, hose - SOLD OUT $0.44
YAMAHA - Fork Spring Compressor $107.10
07936-3710001 - BEARING REMOVER SET, 20 MM $155.49
YAMAHA - CRANKSHAFT INSTALLER A $57.90
YAMAHA - WASHER, claw - SOLD OUT $8.74
91351-KB7-003 - Seal, B dust $2.39
YAMAHA - CLAMP, HOSE - (was 90460-52210) $14.02
SEAT COWL TZ250 98- $336.61